Seymour Duncan Killing Floor High Gain Boost Pedal (Available to Order)

FULFILMENT ORDER
Will be dispatched by the UK distributor upon order

The Killing Floor High Gain Boost gives you both a volume boost and a musical amp-like overdrive all in one, with an unmistakable, undeniable bluesy feel. Use it to boost your overall output for solos, to push an amp further into overdrive, or for a beefy, expressive solo tone. It’s also great as an ‘always on’ pedal for adding the finishing touch to your tone; it’s like an overall enhancer for your entire sound.

The single control knob gives you up to a whopping 34 dB of additional gain for amazing range, from subtle boost to brash chords to a full, fat overdriven lead, while the 3-way Voicing toggle switch lets you sculpt your high end with a boost at 10K, a cut at 4.8K or a flat setting. Use this switch to take the bite out of overly bright single coils, put more sting into a dark humbucker or to add crystal clear, boutique-style airiness to your tone.

The Killing Floor is made in the USA and is True Bypass.

• Type of circuitry: The Killing Floor uses a hybrid J-FET/Op-Amp, optimized for low
• order harmonics
• Bypass: True hard-wire bypass
• Control Functionality:
• Gain Control Range – 0dB to 34dB
• Voicing Switch:
• Up – High Boost, 7 dB @ 10 kHz
• Middle – Flat Response
• Down – High Cut, 1st order, -3dB @4.8 kHz
• Bypass (Footswitch) – Engages the boost effect
• Input Impedance: 1M Ohm
• Output Impedance: 1K Ohms
• Gain: Unity (0dB) dry; off to +3dB wet
• THD @ 1 Vo: Unity (0dB) dry; off to +3dB wet.
• Noise referred to input: 120dBV (with Gain set for 34dB)
• Power: 9V battery or external 9V to 18V Regulated DC Adapter (center negative)
• Current Consumption: 3.7mA in active mode, 2.2mA in bypass mode
• Dimensions: 2.61” X 4.90” X 1.40”
• Weight: 0.8lb. without battery, 0.9lb. with battery